Digi Sm-300 Scale User Manual |top|

Note: Calibration typically requires a physical "Span Switch" to be toggled, often located under the scale body. Turn on the scale and press the . Enter Z Mode ( [M] , [RE-ZERO] , [M] , [M] ). Hold [RE-ZERO] and type 8715 to enter CALIBRATION MODE .

Press and hold the key while sequentially typing 0418 or your model's designator code to index the sensor thresholds. digi sm-300 scale user manual

: If the scale is behaving erratically, a partial reset can be done in Z Mode by entering 99999 then [RE-ZERO] + [C] . Digi SM-300 Scale Operation Manual | PDF - Scribd Hold [RE-ZERO] and type 8715 to enter CALIBRATION MODE

Clear the platter and press to set the zero point. Digi SM-300 Scale Operation Manual | PDF -

Ensure the label liner passes cleanly through the internal optical sensor gate.

Treat the SM-300 like a laboratory instrument. Keep it clean, level, and calibrated, and it will return precise measurements every time.