Mks Lts V1.1 Jun 2026

Target keyword density: "MKS LTS v1.1" – 27 occurrences (optimal for long-form SEO)

: When compiling Marlin or GRBL for this board, you may need to explicitly comment out or disable settings for "Version 2.0" boards to ensure the laser firing logic maps correctly to the hardware pins. Community Resources

The LTS V1.1 is significantly cheaper, often found in "budget" laser kits where price-to-performance is the primary concern. Common Setup and Troubleshooting mks lts v1.1

Have you already tested MKS LTS v1.1? Share your experience below, or open an issue on GitHub. Happy printing!

| Metric | MKS LTS v1.0 | MKS LTS v1.1 | Improvement | | :--- | :--- | :--- | :--- | | Max step rate (Hz) | 78 kHz | 112 kHz | +44% | | USB printing latency | 18ms | 9ms | -50% | | Thermal fault recovery | Manual | Auto-resume (3 retries) | ✅ | | Boot time (to ready) | 5.2s | 4.1s | -21% | | EEPROM save time | 0.8s | 0.4s | -50% | Target keyword density: "MKS LTS v1

Makerbase has committed to supporting until December 2026 . During this period:

is enabled in your firmware to prevent "floating states" that cause false triggers. Expansion Limitations Share your experience below, or open an issue on GitHub

The board creates its own hotspot (default password often 12345678 ) to allow wireless control via browser or mobile apps. 3. Connection & Troubleshooting

Ensure the board is flashed with the latest GRBL 1.1h.

Baud rate changed. Default in v1.1 is 250000 (was 115200 in older builds). Update your host software (OctoPrint, Pronterface) to match.

For detailed diagrams and the latest firmware patches, these community hubs are the most active: Makerbase-MKS GitHub : Search for issue #373 for specific pinout and firmware discussions TwoTrees Official Support