Eurotherm 2208l Manual [new]

(Part No. HA026485)

| Error Code | Meaning | Solution from Manual | | :--- | :--- | :--- | | | Sensor Break | Check thermocouple wiring for open circuit. Replace sensor. | | S.Err | Sensor short or out of range | Check for short in thermocouple leads. Verify input type matches sensor. | | HHHH | Overrange (High) | PV exceeds maximum display range. Check sensor placement. | | LLLL | Underrange (Low) | PV below minimum range. Reverse thermocouple polarity? | | EEEE | Internal EEPROM fault | Cycle power. If persists, contact Eurotherm service for repair. | eurotherm 2208l manual

This guide is a reference summary. For full electrical safety specifications and detailed wiring diagrams, always refer to the official Eurotherm 2208L Engineering Handbook (Part No. HA027985). (Part No

The manual organizes parameters into "Lists." The most important lists are: Check sensor placement

Input sensor connections (e.g., Terminal 25 for TC+, 26 for TC-).

To change how the controller behaves (e.g., changing from a thermocouple to a Pt100 sensor, or setting high limits), you must enter the . The manual is very strict about this process to prevent accidental changes.

| Button/LED | Function | |------------|----------| | (green/red, upper) | Actual temperature/process value | | SV display (lower, green) | Current setpoint | | Page/Scroll (∧ ∨) | Change parameters / setpoint | | Scroll + Access | Enter configuration level | | OUT1 LED | Output 1 active (heating) | | ALM LED | Alarm active |