Jdm-055 Motherboard Schematic

Without these, even a perfect schematic is just a drawing.

Uses a 0.5mm-pitch 16-pin connector for the battery and a 0.3mm-pitch 30-pin connector for the main interface.

The Super I/O chip (commonly an ITE or Nuvoton chip) is the traffic controller. The schematic reveals the pinout for the EC (Embedded Controller). jdm-055 motherboard schematic

Ps4 controller Trace mark on jdm 055 can it be fixed? : r/soldering DualShock 4 Controller PCB scans Acidmods.com

: The schematic shows that the 5V boost converter (TPS61253) can be disabled by lifting its EN pin. This saves ~20mA battery drain. Without these, even a perfect schematic is just a drawing

: Unlike earlier models, the JDM-055 uses specific via locations for the face buttons (Cross, Circle, Triangle, Square) that are shared with the JDM-050 layout. Visual Reference For board identification and component location: JDM-055 (1-982-707-31) Schematic Acidmods.com JDM-055 (1-982-707-31) Schematic Acidmods.com JDM-055 (1-982-707-31) Schematic Acidmods.com JDM-055 (1-982-707-31) Schematic Acidmods.com JDM-055 conductive film map : r/PS4Mods JDM-055 (1-982-707-31) Schematic Acidmods.com

The JDM-055 is part of the "Gen 5.5" controllers (CUH-ZCT2 series). The schematic reveals the pinout for the EC

If you are searching for the you are likely: