Ensure the device has three "tails" (wires) connected: a common neutral, a constant live, and an off-peak live. If the off-peak tail is disconnected, the system will only run on a single tariff.
: Check which rate's reading increases during daytime hours to confirm which is which. Manual Resources
The Series K stores monthly faccette values for each meter. To retrieve: Ensure the device has three "tails" (wires) connected:
– I can write a fictitious but plausible technical manual for a “Horstmann Series K Radio Telemeter,” including registration procedures, faceted dial calibration, and Italian/English interface notes.
It is typically found near your main fuse box or consumer unit. Reading the Display: Manual Resources The Series K stores monthly faccette
The meter typically features a digital LCD display and two buttons: Energylinx Blue Button : Use this to cycle through the different display screens. Red Button
The Series K acts as both a consumption recorder and a remote-controlled switch. It picks up broadcast signals to: Reading the Display: The meter typically features a
This guide is based on typical Horstmann (now part of Honeywell Home) radio telemeter devices used for district heating, submetering, or energy monitoring. The “Serie K” is a receiver/recorder unit that registers pulses from remote radio meters (heat, water, gas).
Activate storage heaters or water tanks during low-cost periods.
