Acrorip 10.7 [2021] ›

Disclaimer: AcroRIP is a trademark of its respective owner. This article is for educational purposes. Always use licensed software.

| Problem | Likely cause | Solution in 10.7 | |---------|--------------|------------------| | White ink not printing | Wrong print mode | Select DTF Dark / White+CMYK | | White bleeds under edges | Choke too low | Increase choke to 1.0–1.5 px | | Colors dull on dark fabric | Underbase too thin | Raise white ink density to 200–250% | | Film sticking after curing | Too much white ink | Reduce white layer to 180–220% | | Print stops mid-job | USB buffer overflow | Enable “Send as one job” in settings | acrorip 10.7

AcroRIP 10.7 introduces several critical improvements over previous versions (like V9 or early V10 releases) to enhance production speed and print quality. Disclaimer: AcroRIP is a trademark of its respective owner

Users in the community have reported several troubleshooting challenges with this version: | Problem | Likely cause | Solution in 10

at the bottom of the sheet or shine a bright light into the printer to help the sensor detect transparent film.